Falcon DOMINATOR PLUS Series Installation And Servicing Instructions

Falcon DOMINATOR PLUS Series Installation And Servicing Instructions

Hide thumbs Also See for DOMINATOR PLUS Series:

Advertisement

E3830, E3860 & E3865
DOMINATOR
INSTALLATION and
SERVICING INSTRUCTIONS
IMPORTANT
The installer must ensure that the installation of the appliance is in conformity with these instructions
and National Regulations in force at the time of installation. Particular attention MUST be paid to:
BS7671 IEE Wiring Regulations
Electricity at Work Regulations
Health And Safety At Work Act
Fire Precautions Act
This appliance has been CE-marked on the basis of compliance with the Low Voltage and EMC
Directives for the voltages stated on the data plate.
WARNING
THIS APPLIANCE MUST BE EARTHED.
:
On completion of the installation, these instructions should be left with the Engineer-in-Charge for
reference during servicing. Further to this, The Users Instructions should be handed over to the User,
having had a demonstration of the operation and cleaning of the appliance.
IT IS MOST IMPORTANT THAT THESE INSTRUCTIONS BE CONSULTED BEFORE INSTALLING
AND COMMISSIONING THIS APPLIANCE. FAILURE TO COMPLY WITH THE SPECIFIED
PROCEDURES MAY RESULT IN DAMAGE OR THE NEED FOR A SERVICE CALL.
PREVENTATIVE MAINTENANCE CONTRACT
In order to obtain maximum performance from this unit we would recommend that a maintenance
contract be arranged with SERVICELINE. Visits may then be made at agreed intervals to carry out
adjustments and repairs. A quotation will be given upon request to the contact numbers below.
WEEE Directive Registration No. WEE/DC0059TT/PRO
At end of unit life, dispose of appliance and any replacement
parts in a safe manner, via a licensed waste handler.
Units are designed to be dismantled easily and recycling of all
material is encouraged whenever practicable.
Falcon Foodservice Equipment
HEAD OFFICE AND WORKS
Wallace View, Hillfoots Road, Stirling. FK9 5PY. Scotland.
SERVICELINE CONTACT
Phone: 01438 363 000
PLUS
Fax: 01438 369 900
Fryers
T100774 Ref. 12

Advertisement

Table of Contents
loading

Summary of Contents for Falcon DOMINATOR PLUS Series

  • Page 1 Units are designed to be dismantled easily and recycling of all material is encouraged whenever practicable. Falcon Foodservice Equipment T100774 Ref. 12 HEAD OFFICE AND WORKS Wallace View, Hillfoots Road, Stirling. FK9 5PY. Scotland.
  • Page 2 IMPORTANT INFORMATION Warranty Policy Shortlist Warranty does not cover :- • Correcting faults caused by incorrect installation of a product. • Where an engineer cannot gain access to a site or a product. • Repeat commission visits. • Replacement of any parts where damage has been caused by misuse. •...
  • Page 3: Section 1 - Installation

    SECTION 1 - INSTALLATION UNLESS OTHERWISE STATED, PARTS WHICH HAVE BEEN PROTECTED BY THE MANUFACTURER ARE NOT TO BE ADJUSTED BY THE INSTALLER. 1.1 MODEL NUMBERS, NETT WEIGHTS and DIMENSIONS Width Depth Height Weig Model (mm) (mm) (mm) (kg) E3830 Fryer E3860 Fryer E3865 Fryer 1.2 SITING...
  • Page 4: Section 2 - Assembly And Commissioning

    SECTION 2 - ASSEMBLY and COMMISSIONING 2.1 ASSEMBLY The appliance is supplied complete and ready to be connected to the mains supply. Position unit in desired location and level it. Turn lower section of each leg clockwise to raise corresponding corner height or anti-clockwise to lower it.
  • Page 5: Section 3 - Servicing And Maintenance

    SECTION 3 - SERVICING and MAINTENANCE BEFORE ATTEMPTING ANY MAINTENANCE TASK, ISOLATE THE APPLIANCE AT THE MAIN SUPPLY. TAKE STEPS TO ENSURE THAT IT MAY NOT BE INADVERTENTLY SWITCHED ON. 3.1 ELECTRICAL CONTROL GEAR The mains terminals are located at rear of unit. The contactor(s) are contained within box at front. To gain access, open door and remove cover panel behind.
  • Page 6: Section 4 - Spares

    3.6 CLEANLINESS To maintain maximum performance, the pan must be kept clean. Periodically, oil must be drained off and the pan should be filled with water and detergent. Boil up contents and drain whilst still hot before flushing out with clean water.
  • Page 7 E3830 WIRING DIAGRAM...
  • Page 8 E3830 CIRCUIT DIAGRAM...
  • Page 9 E3860 WIRING DIAGRAM...
  • Page 10 E3860 CIRCUIT DIAGRAM...
  • Page 11 E3865 WIRING DIAGRAM...
  • Page 12 E3865 CIRCUIT DIAGRAM...

Table of Contents