Aim Lab PathFinder 350S Service Manual page 6

PathFinder 350S Service Manual
Page 6
5.5.4 Locations .............................................................. 62
5.5.5 Profile Gates.......................................................... 63
6. Troubleshooting ...................................................................... 64
6.1 Troubleshooting Tools ........................................................ 64
6.2 Operational Errors (GUI) ..................................................... 64
6.3 LIS / Networking Errors....................................................... 64
6.4 Hardware/Component Failures ............................................. 64
6.4.1 PDS ..................................................................... 64
6.4.2 Initialisation .......................................................... 66
6.4.3 Specific Failure Modes .............................................. 70
6.5 Workcell Controller / Software Failures ................................... 73
6.5.1 Communications Failure ............................................ 73
7. Repairs ................................................................................. 77
7.1 Services Module................................................................ 77
7.1.1 Attaching Auxiliary Air .............................................. 77
7.1.2 Piston Cup Seal....................................................... 78
7.1.3 Replacing Fuses ...................................................... 82
7.2 Carousel......................................................................... 84
7.2.1 Carousel PCB ......................................................... 84
7.2.2 Tube Spin O-Ring..................................................... 85
7.2.3 Barcode Reader Alignment ......................................... 86
7.3 Sorter Module .................................................................. 87
7.3.1 Sorter Axes Electronics ............................................. 87
7.3.2 Main PCB .............................................................. 91
7.3.3 Workcell Controller Hard Drive.................................... 92
7.3.4 ATX Power supply.................................................... 93
7.3.5 Workcell Controller Mother Board ................................ 94
7.3.6 Theta-Axis FFC Cables .............................................. 96
7.3.7 X-Axis Drive Belt ..................................................... 98
7.3.8 Z-Axis Drive Belt ....................................................100
7.4 Specimen Tray ................................................................101
7.4.1 Specimen Tray PCB .................................................101
7.5 Customising the Specimen Tray ............................................102
7.5.1 Removing a Fence ..................................................103
7.5.2 Adding Fences .......................................................104
© Copyright 2010 Aim Lab Pty Ltd Rev E February 2010