AEG BSE882220M User Manual page 45

b) When the programme ends a
signal sounds.
c) Press the rotary knob to turn off
the signal.
Steam Cleaning Plus - the duration
of the function is around 75 minutes.
a) Spray a suitable detergent
uniformly in the oven cavity on
both enamel and steel parts.
b) Turn on the function.
The first part of the programme
ends after around 50 minutes.
c) Wipe the cavity of the oven with
a non-abrasive surface care
sponge. You can use warm water
or oven detergents.
d) The final part of the procedure
starts. The duration of this stage
is around 25 minutes.
3. Wipe the cavity of the oven with a
non-abrasive sponge. You can use
warm water.
After cleaning keep the oven door open
for approximately 1 hour. Wait until the
oven is dry. To speed up the drying you
can heat up the oven with hot air at
temperature 150 °C for approximately 15
minutes. You can get maximum effects of
the cleaning function if you manually
clean the oven immediately after the
function ends.
11.4 Cleaning Reminder
When reminder is displayed cleaning is
necessary. Use the function Steam
Cleaning Plus.
11.5 Steam generation system
- Descaling
When the steam generator operates,
limestone accumulates inside it (because
of calcium contents in the water). This
can have a negative effect on the steam
quality, on the performance of the steam
generator and on the food quality. To
prevent limestone accumulation, clean
the steam generation circuit.
Remove all accessories.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
The duration of the complete procedure
is about 2 hours.
The light in this function is off.
1. Make sure that the water drawer is
empty.
2. Press .
3. Put the grill- / roasting pan on the
first shelf position.
4. Press the rotary knob.
5. Put 250 ml of the descaling agent in
the water drawer.
6. Fill the remaining part of the water
drawer with water to the maximum
level until the signal sounds or the
display shows the message.
7. Press the rotary knob.
This activates the first part of the
procedure: Descaling.
The duration of this part is
around 1 hour 40 minutes.
8. After the end of the first part, empty
the grill- / roasting pan and put it on
the first shelf position again.
9. Press the rotary knob.
10. Fill the water drawer with fresh water
to the maximum level until the signal
sounds or the display shows the
message.
11. Press .
This activates the second part of the
procedure: Descaling. It will rinse the
steam generation circuit.
The duration of this part is
around 35 minutes.
Remove the grill- / roasting pan after the
end of the procedure.
If the function: Descaling is
not performed in the correct
way, the display will show a
message to repeat it.
If the oven is humid or wet, wipe it out
with a dry cloth. Let the oven dry fully
with the door open.
11.6 Descaling reminder
There are two descaling reminders which
remind you to perform the function:
Descaling.
ENGLISH 45