The display with maximum number of
5. BEFORE FIRST USE
Refer to Safety chapters.
5.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories
before the first use.
Put the accessories and the removable
shelf supports back to their initial
5.2 First Connection
After the first connection the software
version will appear for 7 seconds.
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
1. Take the 4 colour change strip
supplied with the steam set in the
2. Put all the reaction zones of the strip
into the water for approximately 1
D E F
0 - 7
0 - 1.3
7 - 14
1.3 - 2.5
14 - 21
2.5 - 3.8
B. Up Timer
C. Heating function and temperature
D. Options or Time of Day
E. Duration time and End time of a
function or Food Sensor
You have to set the language, the
Display Brightness, Water hardness and
the Time of Day.
5.3 Setting the water hardness
When you connect the oven to the mains
you have to set the water hardness level.
The table below shows the water
hardness range (dH) with the
corresponding Calcium deposit and the
quality of the water.
0 - 50
50 - 100
100 - 150
Do not put the strip into the running
3. Shake the strip to remove the excess
of the water.
4. Wait 1 minute and check the water
hardness with the table below.
The colours of the reaction zones
continue to change. Do not check
the water hardness later than 1
minute after test.