Extron electronics EDID 101H 4K PLUS Setup Manual

EDID 101H 4K PLUS • Setup Guide
This setup guide provides instructions for an experienced installer to install and operate the EDID 101H 4K PLUS.
The EDID 101H 4K PLUS is a single-input, single-output HDMI EDID emulator supporting video rates up to 4K@60 Hz 4:4:4. It
supports EDID Minder, HDCP 2.3, and Extron Product Configuration Software (PCS) configuration. The EDID 101H 4K PLUS can
also capture and store EDID information from a connected display via the front panel STORE button.
The EDID 101H 4K PLUS is housed in a 1 inch high, quarter-rack width, 6-inch deep enclosure. An external universal power
supply is included.
For full installation, configuration, menus, connector wiring, and operation details, see the EDID 101H 4K PLUS User
NOTE:
Guide, available at www.extron.com
Rear Panel Cabling
B
A
POWER
12V
0.3A MAX
INPUT
Figure 1. EDID 101H 4K Plus Rear Panel
A
Power Connector — Connect the included 12 VDC power supply to the orange, two-pole, 3.5 mm captive screw
connector. Wire the power supply as shown in figure 2.
A
Smooth
Ridges
SECTION A–A
A
Figure 2. External Power Supply Connection
ATTENTION: Risk of property damage:
ATTENTION : Risque de dommages matériels :
•
Do not connect any external power supplies until you have read the Attention notifications in the Power Supply section
of the user guide for that device.
•
Ne branchez pas de sources d'alimentation externes avant d'avoir lu les mises en garde dans la section « Power Supply
» du guide utilisateur pour cet appareil.
B HDMI Input — Connect an HDMI source to this HDMI connector.
c
HDMI Output — Connect a display or other output device to the HDMI connector.
C
OUTPUT
POWER
12V
0.3A MAX
3/16"
(5 mm) Max.
EDID 101H 4K PLUS
1