Symbol Definitions - Extron electronics EDID 101H 4K PLUS User Manual

Symbol Definitions

] =
CR/LF (carriage return with line feed) (hex 0D 0A)
} =
Soft carriage return (no line feed) (hex 0D)
• =
Space character for a command or response
(hex 20). Other spaces documented are for
clarity only.
W =
Alternate for <Esc> (hex1B)
| =
(pipe symbol) is an alternative to
E = Escape
X@ =
Video mute:
0 = Off (default)
1 = On, video only
2 = Video and Sync
X# = Status
0 = Off, disabled, or undetected
1 = On, enabled, or detected
X$ = Output HDCP Mode:
1= Encrypt as required by input. Continuous
trials for HDMI sinks, attempt for 10s on DVI
sinks (then fail) (Default)
2= Always encrypt. Continuous trials for HDMI
sinks, attempt for 10s on DVI sinks (then fail).
X% = Output TMDS Format:
1= Auto (default),HDMI RGB Full if HDMI sink,
force DVI format if DVI sink.
2= DVI RGB 444 Full
3= HDMI RGB 444 Full
4= HDMI RGB 444 Limited
5= HDMI YUV 444 Limited
6= HDMI YUV 422 Limited
X^ = Slot # on EDID lookup table (1-17), default = 9,
see table page 8. Only 1-16 are addressable by
the user.
X& = 128 or 256 Bytes EDID raw HEX (text form) from
currently assigned EDID.
X* = Native resolution and refresh rate from currently
assigned EDID.
Ex: 1920x1080@60Hz
X( = Output color bit depth: 1= auto based on sink
EDID (default), 2= force 8-bit/color
X1) =
X1! =
X1@ =
X1# =
X1$ =
}
(CR)
Verbose mode:
0=clear/none
1=verbose mode (default)
2=tagged responses for queries
3=verbose mode and tagged responses for
queries.
Device name. The name is a text string up to 24
alphanumeric characters including hyphens (-),
with no spaces. The first character must be a letter,
and the last character cannot be a hyphen.
The default is "EDID-101H-4K".
Input HDCP status:
0 = No video detected
1= Video detected without HDCP (not encrypted)
2 = Video detected with HDCP (encrypted)
Output HDCP status:
0 = No active sink detected
1 = Non-HDCP sink detected
2 = HDCP sink detected not encrypted
Output 5V mode:
1 = Auto (5V enabled when source with 5V
present, else off)
2 = 5V always enabled (default).
EDID 101H 4K PLUS • Remote Control 17