Securing The Hdmi Connector Lockit Lacing Bracket - Extron electronics EDID 101H 4K PLUS User Manual

Securing the HDMI Connector LockIt Lacing Bracket

Follow these instructions to secure the input connectors to the switcher with the LockIt HDMI lacing
bracket provided:
3
1
Figure 4.
1.
Plug the HDMI cable into the rear panel connection (see figure 4,
2.
Loosen the HDMI connection mounting screw from the panel enough to allow the LockIt lacing
bracket to be placed over it
3.
Place the LockIt lacing bracket on the screw and against the HDMI connector
the screw to secure the bracket.
ATTENTION:
•
•
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt lacing bracket as
shown
5.
While holding the connector securely against the lacing bracket, tighten the tie wrap, then remove
any excess length
2
LockIt Lacing Bracket Diagram
. The screw does not have to be removed.
2
Do not overtighten the HDMI connector mounting screw. The shield it fastens to is very
thin and can easily be stripped.
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel elle est
attachée est très fin et peut facilement être dénudé.
.
4
.
5
3
4
5
1
EDID 101H 4K PLUS • Installation and Operation
).
3
, then tighten
6