Clear Cmos (Sw3); At/Atx Setup - Advantech UNO-1483G Series User Manual

A.8

Clear CMOS (SW3)

This switch on the bottom of the board and is used to erase CMOS data and reset
system BIOS information.
Follow the procedures below to clear the CMOS.
1. Turn off the system.
2. Move the switch to PIN 2 to clear CMOS
3. Move the switch back to PIN 1
4. Turn on the system. The CMOS is now cleared.
5. Turn on the system. The BIOS is reset to its default setting.
Note! An alternative method of clearing the CMOS data is to remove the RTC
battery.
A.9

AT/ATX setup

To setup AT/ATX mode, enter into BIOS setup menu, [Chipset]->[Restore AC Power
Loss] options:
1. Power On: AT mode
2. Power off: ATX mode
27 UNO-1483G User Manual