Maintenance Table; Clean The Tool; Lubrication Plan - Signode BXT3-13 Service Manual

2.4

Clean the tool

!
ATTENTION!
Do not use water or other solvent to clean.
See operating instructions, chap. 6.2.
2.5

Lubrication plan

Re-lubricate the device, see operating instructions (Manual), chap. 6.2 and 6.3.
Description
1 Drive train, planetary gear
2
Switchover gear (Attention: exclusive free wheel!)
3
Freewheel (Attention: no grease!)
4
Angular gear
5
Cam disk, resetting lever, coupling shaft
6
Tooth plate, threaded rod
7
All moving parts such as axles, joints, strap guides, etc.
8
Ball guides on the welding shoe, eccentric shaft, knife
guide
* see also maintenance table 2.3.
8 von 37
ENGLISH
7
5
2
3
5
5
Service Manual BXT3-13/16/19
Recommended lubricants
Klüber Microlube GBU-Y 131
Klüber Microlube GBU-Y 131
Universal oil, e.g. WD 40
Klüber Microlube GBU-Y 131
Klüber Microlube GBU-Y 131
Klüberpaste 46 MR 401
High-pressure resistant adhesive
lubricant oil, e.g. Würth HHS 2000
High-pressure resistant adhesive
lubricant oil, e.g. Würth HHS 2000
7
5
7
4
3
8
7
8
6
1
4
Interval*
80,000 cycles
80,000 cycles
80,000 cycles
80,000 cycles
80,000 cycles
80,000 cycles
80,000 cycles
25,000 cycles (see
manual, chap. 6.3)
V 07.17