Conversions, Changes - Judo PROFI-PLUS Series Installation And Operating Instructions Manual

To switch off the beep, press the reset but-
ton on the handwheel cover.
By pressing the button, the time interval
of 2 months is restarted.
After backwashing, turn the setting ring
on the front of the device to the next back-
washing due date, as a reminder.
The signal is just an additional reminder
of the necessary backwashing. Indepen-
dant from this signal, the backwashing
interval indicated in chapter 4.1.1 must be
observed.
Check backwash reminder alarm
Press the reset button for at least 3 sec-
onds:
• Beep: the backwash reminder alarm
works. The batteries still have enough
capacity.
• No beep: replace the batteries by new
leak-proof batteries.
This battery test has no influence on the
backwashing interval.
Replace batteries of the backwash
reminder alarm
1. Remove the handwheel cover.
2. Replace the batteries in the battery com-
partment by new ones of the same type
(size 1.).
3. Refit the handwheel cover.
4. Press the reset button on the handwheel
cover for at least 3 seconds. The time
interval of two months is restarted.
Attention: do not dispose of used batter-
ies with the household waste, but in accor-
dance with the local waste disposal regula-
tions.
12
Operation
4.1.3 Backwashing
WARNING
Persons who, due to their phys-
ical, sensory or mental abilities
or their inexperience or lack of
knowledge, are unable to operate
the device safely may not operate
it without supervision or instruc-
tion from a responsible person.
Before carrying out a backwash,
ensure that the wastewater con-
nection is functional.
At the end of the backwashing
process, turn the handwheel until
it engages so that no more back-
wash water escapes. Otherwise,
water may constantly escape and
cause water damage.
1. Turn handwheel counter-clockwise up to
stop. Backwashing water escapes.
2. Turn handwheel clockwise up to stop.
Ensure that no water escapes.
The backwashing process is completed
(see chapter 4.1).
4.2

Conversions, changes

WARNING
Unauthorised conversions and
changes are forbidden for safety
reasons. These can impair the
functioning of the device, leading
to leaks and, in the worse case
scenario, to bursting of the device.
JUDO JPF+ 1701582 • 2018/12