Loading Setups; The Measurement Parameters; Measure Mode - Keysight N4375D User Manual

User Interface Reference

Loading setups

The Measurement Parameters

Measure Mode

66
Click to retrieve an existing setup.
• After loading a setup with user calibration mode set to
"Measure", the electrical calibration set specified in this
setup is preselected in the optical connection dialog
shown during OE or OO initialization.
This is different to the behavior when doing OE or OO
initialization without loading a setup.
For more details, see
Devices" on page 86
Devices" on page
• After loading a setup with user calibration mode set to
"Load", the specified calibration file is preselected in the
load dialog asking you for the calibration data file during
OE or OO initialization.
For more details, see
Devices" on page 86
Devices" on page
A 2- port network analyzer can only support single- ended
measurements. Selecting the Measure Mode is only possible if
you have a 4- port network analyzer.
Differential
If you select this mode, means the LCA uses a differential
electrical input or output for this measurement.
Whether the differential signal is the input to the DUT or
the output from the DUT, this uses ports 2 and 3 of a four
port network analyzer.
Single-Ended
If you select this mode, the LCA uses a single- ended
electrical input or output for this measurement.
Keysight N4375D Lightwave Component Analyzer, User's Guide
"Measuring Opto- Electrical (OE)
or "Measuring Optical- Optical (OO)
99.
"Measuring Opto- Electrical (OE)
or "Measuring Optical- Optical (OO)
99.