Section 7. Labeling Your System - IBM 5280 User's Setup Manual

Section 7. Labeling Your System
Some labels are placed on the system devices during manufacturing. Other
labels must be placed on the devices by you. The following procedures are for
labeling the keyboard(s), diskette drive(s), and/or printer(s).
LABELING THE KEYBOARDS
label the keyboard by doing the following:
1. Look at your floor plan. The keyboard number(s) on the floor
plan are written on or beside each data station.
These numbers can be 0, 1, 2, or 3.
2. Find the appropriate number on the label sheet (the label
sheet is in the customer setup envelope).
3. Remove the label and stick it within the recess of the label
holder. (The label holder(s) is in the customer setup
envelope.)
Label Holder
4. Remove the protective paper from the label holder; stick the
label holder onto the keyboard, as shown:
Label Holder
Protective Paper
5. Repeat steps 1, 2, 3, and 4 until all of the keyboards on every
data station are numbered.
User's Setup Procedures 87