IBM 5280 User's Setup Manual page 148

86. Press the Enter key and observe this display.
Te.st
C:CHI1P
I.ete.
Option.s· d1"€~
2 . . . Exit
op t i cm:
._.
Pl"(~SS ENTER 52-78
J
87. Press the number 2, then press the Enter key.
The program load screen will be displayed.
88. Make a check mark in the box
ri
below indicating
completion of step 81 through step 87 for this magnetic
stripe reader.
Magnetic Stripe
Reader (Keyboard)
o
2
3
Steps 81-87
Completed
o
D
o
D
You can have a maximum of four magnetic stripe readers on your
system.
89. Move to the next higher numbered keyboard/data station that
has a magnetic stripe reader attached and do the following:
a. Make sure that the verification' diskette is in diskette drive 4000.
b. Key TKBD after the words Program name.
c. Press the Field+ or Field Exit key.
d. Key. 4000 after the words Device address.
e. Press the Enter key.
f. Go to step 81.
When you have completed step 81 through step 89 for each magnetic
stripe reader on your system, read the progress check block and continue
to the next step.
User's Setup Procedures 141