IBM 5280 User's Setup Manual page 122

31. Observe this display.
This display will appear for approximately 30 seconds. ,
D i sket te
i
read/wI- i te te,S't i,I1 pl-ocess.
l
53-03
J
~----------
E1. If the top line of the display starts blinking, press the
Reset or Error Reset key. The following display will
appear.
Test terminated.
Options' are
L Restart
2 .. Exit
option: _.. Press ENTER
53-79
E2. Press the number 1, then press the Enter key.
Repeat step 24 through step 31. If the top line of the
display starts blinking again, record the four-digit error
code number for reference and call your service
representative.
32. Observe this display. Press the Enter key.
Type
i
Test Complete.
Press ENTER 53-04
l~ _ _ _ ------,J
!
J
User's Setup Procedures 115