Diskette 1 Drive System Checkout Procedure - IBM 5280 User's Setup Manual

114
Diskette 1 Drive System Checkout Procedure
27. Press the number 1, then press the Enter key.
28. Observe this display.
Insert verification diskette in drive to be tested and enter
device addl-ess:
I
PI-ess ENTER 53-02
J
~----..------'
29. Determine the device address of the diskette drive where the
verification diskette is located.
The device address is the four-digit number on the label next to the
diskette drive.
30. Key the device address and press the Enter key.
You may have to press and hold the Alpha key while pressing the letter
C in some four-digit numbers of the diskette drive.
After pressing the Enter key, the red light over the device address label will
go on while the diskette drive is in use. If this light does not go on, call
your service representative.