L.B. White Guardian 60 Assembly And Installation Instructions Manual page 9

Mounting the wall brackets and cutting the duct hole
1. Position the brackets at the desired location. Drill holes and fasten both sets of brackets to the wall using quan-
tity 4 item L lag screws and 4 item C washers, at top and bottom holes of brackets. Tighten all securely.
2. Mount the brackets, using a level. Ensure vertical brackets are plumb. See Fig. 16 for cutting the hole for the
duct.
FIG. 16
MODEL "A" (in. / cm)
AD/AW60 6.5 / 16.5
AD/AW100 8.19 / 20.80
Final heater mounting (Requires assistance)
• Lift the heater and guide its duct through the hole.
• Position the heater along its brackets so the end of the duct is fl ush to the inside wall. See Fig. 17.
• Ensure the oblong holes in the heater hanging brackets align to the holes in the main mounting brackets.
• Ensure clearance of heater to wall is as shown in Fig. 18.
• When the desired position is achieved, securely mount the heater to the main brackets using the following
hardware items at all four mounting locations on both heater hanging brackets (see Fig. 19):
- Item K bolts: 4
- Item D washers: 8
- Item E nut: 4
- Item C spacer: 4
"B" (in. / cm)
3.25 / 8.26
1.56 / 3.96
Outdoor Installation Kit • Guardian 60_100
Outdoor Installation Kit
A
B
CUT 10 ¼ IN. X 10 ¼ IN.
(26 cm X 26 cm) HOLE
9