Drain Hose - Fisher & Paykel WashSmart Eco WA 60 Series Installation Instructions Manual

Location
Install the washer on a solid and level floor surface ensuring it has at least 20 mm
clearance on each side. The washer must not be installed on any textured floor coverings
(eg carpets, rugs).
In your washer you will find:
• 1 hose guide.
• 2 inlet hoses.

Drain hose

1. Carefully pull the drain hose out from the back
of the washer by pulling the exposed part of the
hose downward and outward.
2. To guide the drain hose over the tub or
standpipe the hose guide MUST be fitted to the
drain hose.
To prevent siphoning the
drain hose should not
extend more than 20 mm
from the end of the guide.
The height of the standpipe
or tub should be between
850 – 1200 mm. The drain
hose can be trimmed to
length.
3. Place the drain hose in the tub or standpipe. Do
not fit the hose to a drain spigot. Drainage must
not be airtight in order to prevent siphoning.
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/WashSmart_Eco/WA8560E1/User_Guide_WA8560E1/03_Install...
Fitting the drain hose guide
Updated: Wed, 06 May 2020 16:00:17 GMT
Powered by
4