Fisher & Paykel WA1068G1 Installation Instructions Manual

Installation instructions

Unpacking

To ensure the best performance from your new washer please follow the instructions below.
Removing the packaging
1. Remove the outer packaging.
2. Tilt the machine backwards and walk it off the
bottom packer one foot at a time (ensure lid is
still taped down).
3. Remove the bottom packer from under the
machine by tilting the machine backwards and
pulling the packer out the front.
4. Remove the tape, lift the lid and remove the
bowl packer from the bowl
5. Remove the hoses and accessories.
6. Keep the bottom packer and bowl packer in
case they are required for future transit.
Please ensure that the bottom packer has been removed BEFORE OPERATING your
machine.

Location

Your washer must be installed on a level surface and not on any textured floor coverings (eg carpet, rugs) to
ensure that the opening at the bottom of the machine is not obstructed.
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/WashSmart/WA1068G1/User_Guide_WA1068G1/02_Installation...
Fig. 1 Tilt washer backwards to remove packer
Updated: Sat, 30 May 2020 19:03:41 GMT
Powered by
1