User Guidance & Precautions - HighSecLabs SX22D-3 User Manual

SEC TIONS
Table of Contents
oVERVIEW
User Guidance & Precautions
Please read the following User Guidance & Precautions carefully before using
the product:
1. As product powers-up it performs a self-test procedure. In case of self- test
failure for any reason, including jammed buttons, the product will be Inoperable.
Self-test failure will be indicated by the following abnormal lED behavior:
a. All channel-select lEDs will be turned oN and then off;
b. A specific, predefined lED combination will be turned oN;
c. The predefined lED combination will indicate the problem type (jammed
buttons, firmware integrity).
Try to power cycle product. If problem persists please contact your system
administrator or technical support.
2. Product power-up and RfD behavior:
a. by default, after product power-up, the active channel will be computer #1,
indicated by the applicable front panel push button lED lit.
b. Product Restore-to-factory-Default (RfD) function is available via a
physical control button on rear panel. Use a sharp object or paper clip to
hold RfD button pressed for several seconds to initiate an RfD action.
c. RfD action will be indicated by front panel lEDs blinking all together.
d. When product boots after RfD, keyboard and mouse will be mapped to
the active channel #1 and default settings will be restored, erasing all user-
set definitions.
3. The appropriate usage of peripherals (e.g. keyboard, mouse, display,
authentication device) is described in detail in this User Manual's appropriate
sections. Do not connect any authentication device with an external power
source to product.
HSL 2-Port Secure KVM Mini-Matrix
1 2
4. for security reasons products do not support wireless keyboards and mice. In
any case do not connect wireless keyboard/mouse to product.
5. for security reasons products do not support microphone/line-in audio
input. In any case do not connect a microphone to product audio output
port, including headsets.
6. Product is equipped with always-on active anti-tampering system. Any
attempt to open product enclosure will activate the anti-tamper system
indicated by all channel-select lEDs flashing continuously. In this case,
product will be inoperable and warranty void. If product enclosure appears
disrupted or if all channel-select lEDs flash continuously, please remove
product from service immediately and contact technical support.
7. In case a connected device is rejected in the console port group the user will
have the following visual indications:
a. When connecting a non-qualified keyboard, the keyboard will be non-
b. When connecting a non-qualified mouse, the mouse will be non-
c. When connecting a non-qualified display, the video diagnostic lED will
d. When connecting a non-qualified USb device, fUSb lED will flash green
3 4
functional with no visible keyboard strokes on screen when using the
keyboard.
functional with mouse cursor frozen on screen.
flash green and video will not work.
and USb device will be inoperable.
5 6
5