Table of Contents SECTIONS TABLE OF CONTENTS Introduction HSL Secure Mini-Matrix Package Contents Before Installation Tamper-Evident Labels Active Anti-Tampering System Installation Installing the Mini-Matrix Initial Setup Operation Operating the Mini-Matrix HSL Mini-Matrix Quick Setup Guide...
This guide refers to the following models: SX22D-3 - Secure 2P to 2P DVI-I Video KVM Mini-Matrix, PP 3.0 SX22H-3 - Secure 2P to 2P HDMI Video KVM Mini-Matrix, PP 3.0 SX22PH-3 - Secure 2P to 2P DP/HDMI to DP/HDMI Video KVM Mini-Matrix, PP 3.0 SX22PP-3 - Secure 2P to 2P DP to DP Video KVM Mini-Matrix, PP 3.0...
Table of Contents SECTIONS INTRODUCTION Package Contents Inside the product packaging is the following: Model Description Secure 2P to 2P DVI-I / HDMI / DP/HDMI / DP Video KVM Mini-Matrix, PP 3.0 SX22x-3 Power adaptor HSL Mini-Matrix Quick Setup Guide...
Table of Contents SECTIONS INTRODUCTION Before Installation Unpacking the Product • Before opening the product’s sealed packaging, inspect the seal’s condition to assure that the product was not accessed or tampered with during delivery. If the packaging seal looks suspicious contact the HSL support team and do not use the product.
Table of Contents SECTIONS INTRODUCTION Tamper-Evident Labels • The Mini-Matrix KVM Switch uses a holographic tamper evident label to provide visual indications in case of enclosure intrusion attempts. These labels indicate white dots or the text “VOID”, once removed. When opening the product’s packaging, inspect the tampering evident label.
Table of Contents SECTIONS INTRODUCTION Active Anti-Tampering System • The Mini-Matrix KVM Switch is equipped with an always-on active antitampering system. mechanical intrusion is detected by this system, the switch is permanently disabled and the LED blinks continuously. • If the product indicates a tampered state (all LEDs blinking) - call HSL Technical Support and avoid using the product.
Step 1 – Install Cables source computers that have multiple screens (currently available only for Windows) Connect the console port peripherals: (http://highseclabs.com/dl.php?fid=446). • Connect the video displays to the Mini-Matrix primary and secondary display ports and make sure they are powered on.
Page 9
Table of Contents SECTIONS INSTALLATION Step 2 - Power ON the Mini-Matrix Turn ON all the PCs. Connect the power supply and power ON the Mini-Matrix (approximate boot time is 10 seconds). The Mini-Matrix boots into default mode, where the source number 1 is presented on both displays.
Page 10
Table of Contents SECTIONS INSTALLATION Reset to Factory Defaults (optional) Important Notes: Reset to factory defaults clears the device settings and 1. Always use the left control key (Ctrl) unless otherwise specified. restores the device to its original configuration. You have the 2.
Table of Contents SECTIONS OPERATION • Use the front-panel push buttons to independently Operating the Mini-Matrix switch the video/USB/audio/keyboard and mouse ports between the primary and secondary computers. This is Step 1 - Display and Control Options useful for various scenarios, for example: Display and control options define which source to display and ◦...
Table of Contents SECTIONS OPERATION How to define the mouse state Step 2 - Relative vs. Absolute Mouse • Use the key combination { L Ctrl | L Ctrl | F11 | c } to The Mini-Matrix is set up with the following mouse settings: enable absolute mouse (VDT).