Banner SureCross FlexPower DX80 Series Manual page 7

Configurable node with discrete inputs and discrete nmos outputs
Hide thumbs Also See for SureCross FlexPower DX80 Series:
Table of Contents

Advertisement

SureCross DX80 FlexPower Node
Radio range is with the 2 dB antenna that ships with the product.
High-gain antennas are available, but the range depends on the
environment and line of sight. To determine the range of your wire-
less network, perform a Site Survey.
Discrete Inputs
Rating: 3 mA max current at 30V dc
Sample Rate: 125 milliseconds
Report Rate: On change of state
Discrete Input ON Condition
PNP: Greater than 8V
NPN: Less than 0.7V
Discrete Input OFF Condition
PNP: Less than 5V
NPN: Greater than 2V or open
Ratings
DX80 models:IEC IP67; NEMA 6; (See UL section be-
low for any applicable UL specifications)
DX80...C models: IEC IP20; NEMA 1 (In a suitable en-
closure: Class I, Division 2, Group A, B, C, D; T4 −40
to 80 °C)
Operating Conditions
Operating Temperature: −40 to +85 °C (Electronics);
−20 to +80 °C (LCD)
Operating Humidity: 95% max. relative (non-condens-
ing)
Radiated Immunity: 10 V/m, 80-2700 MHz
(EN61000-6-2)
Shock and Vibration
IEC 68-2-6 and IEC 68-2-7
Shock: 30g, 11 millisecond half sine wave, 18 shocks
Vibration: 0.5 mm p-p, 10 to 60 Hz
Included with Model
The following items ship with the DX80 radios.
• BWA-HW-002: DX80 Access Hardware Kit, containing four PG-7 plastic threaded plugs, four PG-7 nylon gland fittings, four PG-7 hex
nuts, one 1/2-inch NPT plug, and one 1/2-inch nylon gland fitting. (Not included with IP20 DX80...C models)
• BWA-HW-001: Mounting Hardware Kit, containing four M5-0.8 x 25mm SS screws, four M5-0.8 x 16mm SS screws, four M5-0.8mm
SS hex nuts, and four #8-32 x 3/4" SS bolts
• BWA-HW-003: PTFE tape
• BWA-9O2-C (900 MHz) or BWA-2O2-C (2.4 GHz): Antenna, 2 dBd Omni, Rubber Swivel RP-SMA Male. (Not included with Internal
antenna models)
• Quick Start Guide (128185 for DX80 Gateways or 152653 for MultiHop models)
• MQDC1-506: 5-Euro (single ended) straight cable, 2m (Not included with FlexPower devices)
• BWA-HW-011: IP20 Screw Terminal Headers (2 pack) (Included only with the IP20 DX80...C models)
Warnings
P/N 136328 Rev. F
Radio and General
Inputs and Outputs
Discrete Outputs
Update Rate: 1 second
ON Condition: Less than 0.7V
OFF Condition: Open
Output State Following Timeout: OFF
Discrete Output Rating (NMOS)
Less than 10 mA max current at 30V dc
ON-State Saturation: Less than 0.7V at 20 mA
Switch Power Outputs (SP1 and SP2)
3.6V dc or 4.3V dc (constant power)
Environmental and Certifications
DX8x...C (External Wiring Terminal Models)
(Ex/A Ex nA II T4); Certificate: 1921239
cate: LCIE 10 ATEX 1012 X
Refer to the
ual
(p/n 132607) for installation and waterproofing instructions. Op-
erating the devices at the maximum operating conditions for exten-
ded periods can shorten the life of the device.
www.bannerengineering.com - tel: 763-544-3164
CSA: Class I, Division 2, Groups A, B, C, D
LCIE/ATEX: Zone 2 (II 3G / Ex nA IIC); Certifi-
SureCross DX80 Wireless I/O Network Product Man-
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Surecross flexpower dx80n9x2s4n4Surecross flexpower dx80n2x2s4n4Surecross flexpower dx80n9x2s4n4cSurecross flexpower dx80n2x2s4n4c

Table of Contents