Modbus Register Table - Banner SureCross FlexPower DX80 Series Manual

Configurable node with discrete inputs and discrete nmos outputs

Hide thumbs Also See for SureCross FlexPower DX80 Series:

Network manual (110 pages)

Product manual (109 pages)

Reference manual (96 pages)

Table of Contents

SureCross DX80 FlexPower Node

FlexPower Discrete Models

SPx. Switch Power. Provides variable

power sources for external devices.

TX/+. Serial comms line for Gateways and

DX85s only. No connection for Nodes

V+. Power, 10 to 30V dc power connec-

tion.

V-. Ground/dc common connection.

Wiring Diagrams for Discrete Inputs

Connecting dc power to the communication pins will cause permanent damage. For the DX8x...C models, PWR in the wiring diagram

refers to V+ on the wiring board and GND in the wiring diagram refers to V- on the wiring board.

Discrete Input Wiring for PNP Sensors

PWR

10-30V dc

DIx

Wiring Diagrams for Discrete Outputs

Connecting dc power to the communication pins will cause permanent damage. For the DX8x...C models, PWR in the wiring diagram

refers to V+ on the wiring board and GND in the wiring diagram refers to V- on the wiring board.

Discrete Output Wiring (NPN or NMOS)

PWR

DOx

Load

GND

LED Behavior for the Nodes

After powering up and binding the Gateway and its Nodes, verify all devices are communicating properly. A Node will not sample its

inputs until it is communicating with its Gateway. When testing communication between the Gateway and Node, all radios and antennas

should be at least two meters apart or the communications may fail.

LED 1

(flashing green)

(flashing red)