Using The G1 Scba And Motorola Apx Radio - MSA G1 SCBA Pairing Manual

G1 SCBA Radio Pairing Guide |
Using Paired
G1 & Radio
Confirm that the Motorola APX Radio Pairing Tag is applied to the G1 SCBA. (Or was applied previously and pair is saved)
Step 1. Turn on the Motorola APX Radio using volume knob.
Step 2. Don the G1 SCBA and securely attach the G1 Facepiece to your face.
A poor facepiece seal can cause improper microphone performance, such as
intermittent audio.
Step 3. Turn on the G1 SCBA via pressurization.
• The G1 SCBA will try to establish a Bluetooth connection to the currently
paired radio for up to 8 minutes.
When found, it will quickly connect and disconnect, (and is now ready to
•
automatically activate when breathing.)
If the connection is not established, repeat the pairing process described in the
previous section.
Step 4. Begin breathing (with the regulator attached).
The radio and SCBA will connect automatically (approx. 20 seconds).
All SCBA voice communication will now go from the SCBA through the portable radio.
Use Notes & Tips:
• Turn on the radio before you turn on the G1 SCBA.
• If the regulator is shut off, The G1 SCBA will not remain connected to the radio. The radio can be used by itself
(no Bluetooth connection) when the regulator is shut off. The G1 SCBA will automatically reconnect to the
Kenwood radio when breathing on the G1 regulator resumes.
• Verify both the incoming and outgoing audio functionality after you have established the Bluetooth wireless
connection.
Rev. 2-11-2019
Motorola APX

Using the G1 SCBA and Motorola APX Radio

Page 9 of 11