Pairing A G1 Scba And Motorola Apx Radio - MSA G1 SCBA Pairing Manual

For motorola apx 4000 series, apx 5000 series, apx 6000 series, apx 7000 series, apx 8000 series

Hide thumbs Also See for G1 SCBA:

Operating manual (97 pages)

Instruction manual (88 pages)

Manual (24 pages)

Table Of Contents

Table of Contents

G1 SCBA Radio Pairing Guide |

Pairing G1 &

Radio

Ensure the radio is programmed correctly to connect with the G1 SCBA. Necessary and recommended settings are listed

in the "Motorola APX Configuration Settings" Section. Consult with your Radio Technician as necessary.

Step 1.

Turn on the Motorola APX Radio using volume knob.

Step 2.

Verify Bluetooth icon is visible on radio display. (That Bluetooth capability is

enabled)

If not visible, enable the radio's Bluetooth OR reconfigure radio.

Step 3.

Power on the G1 SCBA.

Step 4.

Press & hold either of the

RFID mode.

For iTic Control modules: Press & Hold Both Green Buttons.

Step 5.

Place the RFID the Motorola APX Radio's Pairing Tag over the G1 Power

Module RFID Target.

Step 6.

Pair the Radio:

For Single Display Radios:

- Press & Hold middle (1-dot) button on the radio (approx. 30 seconds).

- The radio will give an audible indication when pairing is complete.

For a Dual Display Radios:

- A pairing request will appear on the radio display, accept the pairing request

using the radio menu button. The radio will give an audible indication when

pairing is complete.

The G1 SCBA & Kenwood Radio is now paired and ready for use.

After a successful pairing, if the regulator is shut off, the G1 SCBA will not remain

•

connected to the radio, and the radio is available for non-Bluetooth use.

The G1 SCBA will automatically reconnect to the radio when the end user turns on

•

the G1 regulator & breathes.

Rev. 2-11-2019

Motorola APX