Creating A G1 Scba Configuration Tag (G1 Bluetooth Settings) - MSA G1 SCBA Pairing Manual

G1 SCBA Radio Pairing Guide |
G1 Bluetooth
Settings Tag
The purpose of this section is to: (1) enable the Bluetooth radio on the G1 SCBA and
Step 1. Launch the MSA A2 Software
Step 2. Select the "G1 Tags" Tile on the A2 Dashboard (Under the "G1 Devices"
column)
Step 3. Select tag type: "G1 Configurations"
Step 4. Select the Add (+) icon (top-right) to create the configuration template, which
will be used to change these 2 settings.
Note: This tag can be written without saving a template, but a template can be
saved using the Save Icon (top-right) if a template Name is filled in.
Step 5. Enabling the G1 SCBA's Bluetooth Radio:
(A) Expand the "Bluetooth Settings" section.
(B) Change "Bluetooth Disabled/Enabled" setting to "Enabled".
Step 6.
Preference Choice: "Bluetooth Pair Save" setting options:)
(A) Require Radio Pairing Tag in every SCBA is turned on, choose "Disabled"
(B) To retain the Radio Pairing on the SCBA until "clearing the pair" *, choose
"Enabled"
* - defined on the "Removing Radio Pairing Info from the G1 SCBA" page.
Step 7. Writing the G1 Configuration Tag:
(A) Place RFID Tag on the RFID Reader / Writer
(B) Select the Write G1 Tag icon (top-right side of A2 application)
Step 8. Applying the G1 Configuration Tag to the G1 SCBA(s):
(A) Power on the G1 SCBA
(B) Press & hold either of the
RFID mode. For iTic Control modules: Press & Hold Both Green Buttons.
(C) Place Bluetooth Pairing Save Tag over G1 Power Module RFID Target.
The G1 SCBA is now configured with the settings:
- G1 Bluetooth is now enabled - G1 Bluetooth Pair Save (as chosen).
The G1 SCBA is now ready to accept a Radio Pairing tag.
Repeat this "Step 8" for each SCBA to apply these 2 settings.
Rev. 2-11-2019
Motorola APX

Creating a G1 SCBA Configuration Tag (G1 Bluetooth Settings)

(2) to set Bluetooth Pair Save behavior based on the department's preference.
green Control Module buttons to activate the
Page 5 of 11