Blocking Channels; Unlocking Programs Temporarily; Locking Video Inputs - Toshiba TheaterWide 51H94 Owner's Manual

Blocking channels

With the CHANNELS BLOCK feature, you can block specific
channels. You will not be able to tune locked channels unless
you clear the setting first.
To block channels:
1. Press MENU and highlight the LOCKS menu icon.
2. Press z, which displays the PIN code entering screen.
3. Enter your four-digit PIN code (see page 88 for details).
4. Press z to highlight CHANNELS BLOCK and then press
ENTER.
Locks
Enable Rating Blocking Off
Edit Rating Limits
Channels Block
Input Lock Off
Front Panel Lock Off
Game Timer
Off
New PIN Code
DVD RTN
Navigate Select
CH RTN
5. Press yzx • to highlight the channel you want to block,
then press ENTER, which puts an X in the box next to that
channel.
6. Repeat step 5 for other channels you want to block.
7. Highlight SAVE and press ENTER.
To unlock individual channels:
In step 5 above, press yzx • to highlight the channel you
want to unblock, and then press ENTER to remove the X
from the box.
To block all channels at once:
Highlight BLOCK ALL in step 5 above.
To unlock all locked channels at once:
Highlight ALLOW ALL in step 5 above.
90
H94(E)088-91(9-Locks) 90
Chapter 9: Using the Locks menu
Off
30 Min
60 Min
90 Min
120 Min
Back Exit
EXIT
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.

Unlocking programs temporarily

If you try to watch a TV program that exceeds the rating limits
you set, the TV enters program lock mode.
You can either unlock the program temporarily or select a
non-locked program to watch.
To temporarily unlock the program:
1. Press MUTE.
2. Enter your four-digit PIN code and press ENTER.
If the correct code is entered,
the program lock mode is
released and the normal
picture appears. All locking is
disabled until the TV is
turned off, and will be enabled
when the TV is turned on
again.

Locking video inputs

You can use the INPUT LOCK feature to lock the video input
sources (VIDEO 1, VIDEO 2, VIDEO 3, ColorStream HD-1,
ColorStream HD-2, DVI/HDCP) and channels 3 and 4.
You will not be able to view the input sources or channels until
you turn off the input lock.
To lock the video inputs:
1. Press MENU and highlight the LOCKS menu icon.
2. Press z to display the PIN code entering screen.
3. Enter your four-digit PIN code and press ENTER.
4. Press z to highlight INPUT LOCK and press ENTER.
5. Press z to select the level of video input locking you prefer,
as described below:
VIDEO: Locks VIDEO 1,
VIDEO 2, VIDEO 3,
ColorStream HD1/HD2,
and HDMI.
VIDEO+: Locks VIDEO 1,
VIDEO 2, VIDEO 3,
ColorStream HD1/HD2,
HDMI, and channels 3
and 4. Select VIDEO+ if you use the antenna terminal to
play a video tape.
Note: Make sure the POP is not on channel 3 or 4.
OFF: Unlocks all video input sources.
8/3/04, 6:46 PM
Locks
Enable Rating Blocking Off Off
Edit Rating Limits
Video
Video +
Channels Block
Input Lock Off
Front Panel Lock
Off
Game Timer Off
New PIN Code
DVD RTN
Navigate Select Back Exit
CH RTN EXIT