Using The Srs Wow™ Surround Sound Feature; Turning Off The Built-In Speakers; Selecting The Optical Audio Output Format - Toshiba TheaterWide 51H94 Owner's Manual

Adjusting the audio
Using the SRS WOW™ surround sound
feature
WOW is a special combination of SRS Labs audio technologies
(SRS 3D, FOCUS, and TruBass) that creates a thrilling
surround sound experience with deep, rich bass from stereo
sound sources. Your TV's audio will sound fuller, richer, and
wider.
To adjust the WOW settings:
1. Put the TV in STEREO mode (see "Selecting stereo/SAP
broadcasts" on page 81).
2. Press MENU and open the AUDIO menu.
3. Highlight ADVANCED AUDIO SETTINGS and press
ENTER.
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
DVD RTN
Navigate Select Back
CH RTN
4. Press z or y to highlight the WOW feature you want to
adjust, and then press x or • to adjust the item.
• 3D — To turn the surround sound effect on or off.
Note: If the broadcast is monaural, the 3D effect does not
work.
• Focus — To turn the vocal emphasis effect on or off.
• TruBass — To select the desired bass expansion level
(HIGH, LOW, or OFF).
5. To temporarily save the new settings, highlight DONE and
press ENTER. To permanently save the new settings,
highlight SAVE and press ENTER.
To reset the WOW settings:
Highlight RESET in the Advanced Audio Settings menu
and press ENTER.
Advanced Audio Settings
SRS WOW:3D
SRS WOW:Focus
SRS WOW:TruBass
Reset Save
________
SRS, WOW and the logo are trademarks of SRS Labs, Inc.
SRS WOW technology is incorporated under license from SRS Labs, Inc.
H94(E)077-83(8b-UseTV) 83
Chapter 8: Using the TV's features
(continued)
Advanced Audio Settings
SRS WOW:3D Off
SRS WOW:Focus Off
SRS WOW:TruBass Off
Reset Save Done
Exit
EXIT
Off
Off
Off
Done
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.

Turning off the built-in speakers

Use this feature to turn off the TV speakers when you connect
an audio system to your TV (see "Connecting a digital audio
system" and "Connecting an analog audio system" on page 20).
To turn off the built-in speakers:
1. Press MENU and open the AUDIO menu.
2. Highlight AUDIO SETUP and press ENTER.
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
DVD RTN
Navigate Select Back Exit
CH RTN EXIT
3. Press z to highlight the SPEAKERS field, and then
press • to select OFF.
4. To temporarily save the new settings, highlight DONE and
press ENTER. To permanently save the new settings,
highlight SAVE and press ENTER.
To turn on the built-in speakers:
Select ON in step 3 above.
Selecting the optical audio output
format
Use this feature to select the optical audio output format when
you connect a Dolby Digital decoder or other digital audio
system to the OPTICAL AUDIO OUT jack on the TV (see
"Connecting a digital audio system" on page 20).
To select the optical audio output format:
1. Press MENU and open the AUDIO menu.
2. Highlight AUDIO SETUP and press ENTER.
3. Press z to highlight the OPTICAL OUTPUT FORMAT
field, and then press • to select either DOLBY DIGITAL
or PCM, depending on your device.
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
DVD RTN
Navigate Select Back Exit
EXIT
CH RTN
4. To temporarily save the new settings, highlight DONE and
press ENTER. To permanently save the new settings,
highlight SAVE and press ENTER.
8/3/04, 6:37 PM
83