Setting The Sleep Timer; Displaying Tv Setting Information On-Screen; Understanding The Auto Power Off Feature; Understanding The Last Mode Memory Feature - Toshiba TheaterWide 51H94 Owner's Manual

Setting the sleep timer

You can set the sleep timer to turn off the TV after a set length
of time (maximum of 3 hours).
The sleep timer turns off the TV one time only, as opposed to
the ON/OFF timer, which turns off the TV on a recurring basis.
To set the sleep timer:
Press SLEEP on the remote control to set the length of time
until the TV turns off. Each time you press SLEEP, the time
will increase in 10-minute increments, to a maximum of
180 minutes.
To cancel the sleep timer:
Press SLEEP until it is set to 0.
+10
–
100
ACTION
MENU
ENTER
To set the sleep timer using the on-screen menus:
1. Press MENU and open the SETUP menu.
2. Press z to highlight SLEEP TIMER and press ENTER.
Setup
Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection
Auto
Side Show Interval 2 Sec
AVHD Skip Time 15 min
Convergence
DVD RTN
Navigate Select Back
CH RTN
3. Press the Number buttons to enter the length of time until
the TV turns off automatically.
Sleep Timer
Enter total minutes until the TV turns off
automatically(Maximum 180 minutes)
1 8 0
Save Cancel
4. Highlight SAVE and press ENTER.
Note:
• When a power failure occurs, the sleep timer setting may be
cleared.
• To display the amount of time left on the sleep timer, press
RECALL.
H94(E)084-87(8c-UseTV) 87
Chapter 8: Using the TV's features
SLEEP
Exit
EXIT
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
Displaying TV setting information
on-screen
Press RECALL to display the following information on-screen:
• Current input (ANT 1, ANT 2, VIDEO 1, etc.)
• If ANT 1 or ANT 2 is the current input, whether it is
Cable TV ("CABLE") or off-air ("TV")
• Channel number (if in ANT 1 or ANT 2 mode)
• Time (if set)
• Timer settings (if set)
• Remaining time on sleep
timer (if set)
• Remaining time on game
timer (if set)
• Stereo or SAP audio
status
• V-Chip rating status
• Picture size
Understanding the auto power off
feature
The TV will automatically turn itself off after approximately 15
minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT 1 and ANT 2 modes only.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the TV, the Last
Mode Memory feature automatically turns on the TV when
the power is resupplied.
NOTE: Because the Last Mode Memory feature will cause the
TV to turn on after a power failure (if it was on when the power
failed), if you are viewing fixed images or special formats when
the power fails, such images or formats could be displayed when
the power returns. To prevent possible damage to the TV's
picture tube, you should unplug the TV's power cord if it is
possible that you will be away from the TV for an extended
period of time after the power is restored. If you are away, the TV
could turn on automatically, displaying fixed images or special
formats that can become permanently engrained in the picture
tube. THIS TYPE OF DAMAGE IS NOT COVERED BY YOUR
WARRANTY. See item 33 on page 4.
8/3/04, 6:44 PM
33 34 3 5
STEREO
TV – PG L V
On Timer: Every Day 6:00am
Sleep Timer: 60 min.
ANT1
Full 5:09 pm CABLE 2
Sample RECALL screen
87