Toshiba TheaterWide 51H94 Owner's Manual page 24

Connecting IEEE-1394 video devices
IEEE-1394 device management
The IEEE-1394 device information is saved in the TV's
memory. You can edit this device information (for example, to
edit the device name, change the analog input information, or
delete the device information from the TV's memory if you no
longer use that device).
To edit the IEEE-1394 device information:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3 below).
Setup
Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection Auto
Side Show Interval
2 Sec
AVHD Skip Time 15 min
Convergence
DVD RTN
Navigate Select Back
CH RTN
3. Open the DEVICES menu, highlight IEEE-1394
DEVICES, and press ENTER.
Devices
IEE-1394 Devices
TheaterNet Devices
DVD RTN
Navigate Select Back
CH RTN
4. Highlight the device you want to edit and press ENTER.
5. Follow the on-screen prompts to modify the device
information.
24
H94(E)012-25(2B-Cnct) 24
Chapter 2: Connecting your TV
Exit
EXIT
Exit
EXIT
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
(continued)
Important information regarding
IEEE-1394 device interconnection
Note:
• Do not loop the last device in the chain back to the TV.
If the device chain is looped, the TV may not work properly with the
other devices in the chain.
• Place devices with the slowest communication speed at
the end of each chain. If a device with a slower communication
speed is placed ahead of a faster device in the chain, the signal
from the slower device will interfere with the signal from the faster
device. To determine the communication speed of an IEEE-1394
device, look for an "S" number near the device's IEEE-1394
connector. The higher the "S" number, the faster the device. If your
device is not marked with an "S" number, look in the device's user
manual or call the device manufacturer's technical support number.
• If your IEEE-1394 device has a two-position power
switch, place the device at the end of the chain or leave
the power switch ON at all times. If the power switch is OFF,
it will interfere with signals from devices behind it in the chain.
• The maximum length for an IEEE-1394 cable between
each device is 15 feet.
• This TV is an IEEE-1394A device. The IEEE-1394B protocol is
faster and intended to allow for longer distances between devices
and multi-room systems. IEEE-1394A–to–IEEE-1394B converters
(available at some electronics suppliers) may allow compatibility of
IEEE-1394B devices with your existing IEEE-1394A devices.
• The transmission capability of IEEE-1394 cable used with this TV
must be S400 (400 Mbps maximum).
8/3/04, 3:43 PM