Manually Adding And Deleting Channels In The Channel Memory - Toshiba TheaterWide 51H94 Owner's Manual

Programming channels into the TV's channel memory
Manually adding and deleting channels
in the channel memory
After you have programmed the channels automatically, you can
manually add or delete individual channels in the channel
memory.
To add or delete channels in the channel memory:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3).
Setup
Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection
Auto
Side Show Interval 2 Sec
AVHD Skip Time 15 min
Convergence
DVD RTN
Navigate Select Back
CH RTN
3. Open the TERRESTRIAL menu, highlight CHANNEL
ADD/DELETE, and then press ENTER.
Note: If you have a cable box connected to ANT 1 during
TV Guide On Screen setup, the TERRESTRIAL menu will not
be accessible and you must then use the TV Guide
On Screen channel editor to add/delete channels.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
DVD RTN
Navigate Select Back
CH RTN
4. The illustration below shows channels programmed for the
ANT 1 antenna input. To view the list of channels
programmed for the ANT 2 antenna input, highlight
CHANGE ANTENNA and press ENTER.
Channel Add/Delete
Channel Signal Antenna
2 Analog 1
3 Analog 1
4 Analog 1
5 Analog 1
6 Analog 1
7 Analog 1
8 Analog 1
42
H94(E)040-43(6a-Setup) 42
Chapter 6: Setting up your TV
Exit
EXIT
Exit
EXIT
Change Antenna
Clear All
Save
Cancel
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
(continued)
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number
you want to add, and then press ENTER to check the box.
To manually add digital subchannels on a physical channel:
Use the Channel Numbers and the Dash (–/100) on the
remote control to enter the channel number (for example,
56–1).
If the channel is found, the number will be added to the list
and the box will be checked.
If the channel is not found, a message will appear.
To remove a channel from the channel memory:
Highlight the checked box next to the channel number you
want to remove, and then press ENTER to uncheck the
box.
To save your new settings:
Highlight SAVE and press ENTER.
To revert to your original settings:
Highlight CANCEL and press ENTER before saving.
To remove all channels from the channel memory:
Highlight CLEAR ALL and press ENTER, and then
highlight SAVE and press ENTER.
Note:
• This action applies to the current antenna input only.
To delete/add channels on the other input, highlight
CHANGE ANTENNA and press ENTER.
• This action cannot be cancelled unless you highlight
CANCEL and press ENTER before saving your changes.
Channel Add/Delete
Channel Signal Antenna
2 Analog 1
3 Analog 1
4 Analog 1
5 Analog 1
Change Antenna
6 Analog 1
Clear All
7 Analog 1
Save
8 Analog 1
Cancel
8/3/04, 5:22 PM