Adjusting The Color Convergence - Toshiba TheaterWide 51H94 Owner's Manual

Adjusting the color convergence

This projection TV uses three separate image tubes: red, green,
and blue. The red, green, and blue images are projected onto the
screen where they converge to form a full-color picture. You can
see a clear picture only when the three images converge correctly.
Convergence may drift over time or if you move the TV. If you
can see clear images on your TV screen, skip this procedure.
This adjustment should be made only after the TV has been on
for at least 30 minutes.
Automatically adjusting the color
convergence using TouchFocus
To automatically adjust the color convergence:
Press TouchFocus on the TV front panel one time.
TV front panel
MENU VOLUME CHANNEL
The TV will enter the auto convergence mode.
TOUCH FOCUS
TOUCH FOCUS F I N I SHED
When adjustment is complete, the normal picture will
reappear.
You can adjust the convergence manually described at right
for more detailed convergence adjustment.
H94(E)044-52(6b-Setup) 49
Chapter 6: Setting up your TV
®
EXIT TV/VIDEO TouchFocus
TouchFocus
Horizontal
B R G
Vertical
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
Manually adjusting the color
convergence
To check and adjust the color convergence manually:
1. Press MENU and open the SETUP menu.
2. Highlight CONVERGENCE and press ENTER.
Setup
Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection Auto
Side Show Interval 2 Sec
AVHD Skip Time 15 min
Convergence
DVD RTN
Navigate Select Back Exit
EXIT
CH RTN
3. When the convergence screen appears, press ENTER.
The TV will enter auto-convergence mode. When the
adjustment is complete, the TV will enter 56-point
convergence mode automatically.
cursor
: TO SELECT POS I T I ON
ENTER : TO ADJUST CONVERGENCE
EX I T : TO F I N I SH ADJUSTMENT
If you see separate red, blue, or green crossed lines (or red
or blue shadows next to white lines), you need to adjust the
convergence.
4. Press yzx • to move the cursor to the position you want
to adjust.
5. Press ENTER repeatedly to select RED or BLUE adjusting
mode (red crossed lines or blue crossed lines), depending on
which color needs adjusting.
6. Press y (up), z (down), x (left), or • (right) on the remote
control to converge the red or blue line into the white line.
: TO ADJUST RED
ENTER : TO CHANGE COLOR
EX I T : TO F I N I SH ADJUSTMENT
: TO ADJUST BLUE
ENTER : TO SELECT POS I T I ON
EX I T : TO F I N I SH ADJUSTMENT
8/3/04, 5:28 PM
49