Chapter 6: Setting Up Your Tv; Selecting The Menu Language; Configuring The Antenna Input Sources - Toshiba TheaterWide 51H94 Owner's Manual

6
Setting up your TV
For menu navigation instructions, see Chapter 4.

Selecting the menu language

You can choose from three different languages (English, French
and Spanish) for the on-screen display of adjustment menus and
messages. (The TV Guide On Screen menus are in English,
regardless of the language selected in this menu.)
To select the menu language:
1. Press MENU and open the PREFERENCES menu.
2. Highlight MENU LANGUAGE and press ENTER.
3. Highlight your preferred menu language in the menu
sidebar and press ENTER.
Preferences
Favorite Channels English
Closed Caption Mode Off Español
Closed Caption Advanced Français
Input Labeling
Menu Language English
DVD RTN
Navigate Select Back
CH RTN
4. Press EXIT to close the PREFERENCES menu.
40
H94(E)040-43(6a-Setup) 40
Exit
EXIT
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
Configuring the antenna input
sources
To configure the ANT 1 and ANT 2 input sources:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3 below.)
Setup
Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection Auto
Side Show Interval 2 Sec
AVHD Skip Time 15 min
Convergence
DVD RTN
Navigate Select Back Exit
EXIT
CH RTN
3. Open the TERRESTRIAL menu, highlight INPUT
CONFIGURATION, and press ENTER.
Note: The TERRESTRIAL menu may not be accessible
(items will be "grayed out") in some instances (for example, if
a cable box is connected to the ANT 1 input or if one of the
VIDEO modes is the current input during TV Guide On
Screen setup).
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
DVD RTN
Navigate Select Back Exit
CH RTN EXIT
4. Press • to select the input source (Cable or antenna) for the
ANT 1 input on the TV.
Note: If a cable box is connected to the ANT 1 input during
TV Guide On Screen setup, the entire TERRESTRIAL menu
will not be accessible, including the input source for ANT 1,
which will automatically display "Cable Box. "
5. Press z and then • to select the input source (Cable or
antenna) for the ANT 2 input on the TV, if applicable. If
you have not connected anything to ANT 2, skip this step.
Input Configuration
Antenna 1 In Cable
Antenna
Antenna 2 In
Save Cancel
6. To save your new settings: Highlight SAVE and press
ENTER.
To revert to your original settings: Highlight CANCEL
and press ENTER before saving.
8/3/04, 5:22 PM