Toshiba B-570 SERIES Owner's Manual page 136

6. DIAG. TEST OPERATION
6.4.2 Process Test Print
In the process test print, the test print is automatically performed on the following conditions.
Parameter setting and print tone fine adjustment value is ignored.
OPERATION
ISSUE COUNT : 5 labels each
PRINT SPEED : 8 inches/sec.
SENSOR
RIBBON
TYPE
LABEL LENGTH: 76 mm
PRINT TONE FINE ADJUSTMENT VALUE : + 0
Operating procedure for the test mode is provided below.
From C on
the next page.
Press the [RESTSRT]
key.
To A of the
preceding page.
: One label feed, 3-dot slant line print, bar code print, character print
: Transmissive sensor (feed gap sensor) or reflective sensor (black mark
sensor)
: Transmissive ribbon
: Batch (without cut)
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 >
D I A G N O S T I C
Press the [FEED] key twice.
< 3 >
T E S T P R I N T
Press the [PAUSE] key.
P R I N T C O N D I T I O N
Press the [RESTART] key.
After feeding one label, slant
lines (3 dots) are printed on 5
labels.
A U T O P R I N T ( R E F L E C T . )
Press the [PAUSE] key.
[Bar codes are printed on 5 labels.]
To be continued on
B of the next page.
V 1 . O A
6-46
EM18-33010A
(Revision Date Jan. 13, '95)
6.4 TEST PRINT MODE
Press the [FEED] key
and [RESTART] key
at the same time.
To C of the
preceding page.