Table of Contents
Advertisement
Models 225006, 225026,
240880, 240881, and 245696 (Fig. 3)
1. For Models 225006 and 240880: Assemble the
base (3) as shown in the parts drawing on
page 15.
For Models 225026, 240881, 245696: Assemble
the truck (3) as shown in the parts drawing on
page 14.
2. Remove the fluid outlet adapter included with the
pump, and screw the holster (6) into the pump
outlet, using thread sealant.
3. Place an open 120-lb drum of grease on mounting
base or truck and secure it with the hold-down
clamps.
For portable base models, 225006 and 240880:
For steel drums use pointed end of (3c). Position
clamps above drum bead. Tighten bolts (3b). For
fiber drums reverse (3c) to use flat–end.
For truck model, 225026, 245696 and 240881: For
steel drums use pointed–end of (3c). Position
clamp above drum bead. Tighten thumbnuts (3d).
4. Press the follow plate (5) down firmly onto the
grease, and rotate it to eliminate air pockets and
reduce channeling. Insert the pump through the
cover (4). Slide the cover up far enough to let the
pump pass easily through the follow plate
grommet.
5. Secure the cover on the drum with the
thumbscrews (A). It is not necessary to bolt the
pump to the cover.
6. Assemble the gun (2b) and hose (2a), and connect
the hose to the pump fluid outlet.
7. Connect the nipple (2d) to the pump air inlet or air
regulator (7b) inlet, whichever is applicable.
Connect the quick-disconnect coupler (2c) to the
air supply hose.
Installation
2c, 2d
2b
Fig. 3
7b
4
5
3c, 3d
Model 240881 shown
2a
6
A
3
3b, 3c
01516A
307878
7
Advertisement
Table of Contents
