Table of Contents
Advertisement
Models 226012 and 240886 (Fig. 6)
1. Assemble the truck as shown in the Parts Drawing
on page 14 but do not assemble the handle.
2. Slide handle through elevator slide tube and
secure handle to base.
3. Remove the fluid outlet adapter included with the
pump, and screw the holster (6) into the pump
outlet, using thread sealant.
4. Secure pump to elevator mounting plate.
5. Remove inductor plate locking nut, locking ring,
and o–ring (Fig. 7).
6. In order, slide inductor plate locking nut, locking
ring, and o–ring on pump riser tube.
7. Adjust the inductor plate on the pump riser tube
so the slots are showing just below the inside of
the plate (Fig. 7). TIghten the locking nut securely
8. Open the inductor plate vent by turning the knob
counterclockwise.
9. Place an open 50-lb pail of grease on the truck,
and secure it with the hold-down clamps.
10. Remove the cover from the pail, and scoop the
lubricant from the center to the sides of the pail to
make its surface concave.
11. Center the inductor plate (5) in the pail opening.
Press down on the pump and rock it back and
forth to seat the inductor plate to eliminate air
pockets. Continue action until material appears at
the vent opening.
12. Close the inductor plate vent by turning the knob
clockwise.
13. Assemble the gun (2b), Z–swivel, and hose (2a).
Connect hose (2a) to holster (6) or to pump fluid
outlet adapter if you chose not to use the holster.
14. Connect the nipple (2d) to the pump air inlet or air
regulator (7b) inlet, whichever is applicable.
Connect the quick-disconnect coupler (2c) to the
air supply hose.
10
307878
Installation
2c, 2d
2b
Fig. 6
Pump intake slots
Fig. 7
7b
3c, 3d
Model 240886 shown
Pump riser tube
Locking ring
5
2a
6
5
7462B
Locking nut
1/8" (3 mm)
06383
Advertisement
Table of Contents
