Keysight Technologies B2960A Demo Manual page 6

Using an external trigger to generate pulses with 6.5 digit low noise power source

06 | Keysight | Using an External Trigger to Generate Pulses with the B2960A – Demo Guide

5) Press

, then press

Pulse source mode, you can see the Source Shape which shows the pulse source mode

enabled.

6) Rotate

to select Channel 1 Pulse Parameters and set them up as below.

(Peak: 2 V, Delay: 300 μs, Width: 200 μs)

3. Configure the trigger condition

1) Press

to show the Trigger Sub-Panel.

2) Rotate

to edit the Trigger type, and then select

to MANUAL.

3) Rotate

to select the Source trigger period and press

enter 500 μs to set the Source trigger period to 500 μs, which is the sum of the

pulse delay and the pulse width.

to turn on Pulse source mode. After turning on the

to set the Trigger type

to edit it. Then