Prohibiting The Change Of Parameter Settings; Operation Panel Parameters - Toshiba TOSVERT VF-nC1 Instruction Manual

6.14.9 Analog input disconnection detection
• Function
This parameter is used to detect a break in an analog signal to the VI/S3 terminal. If an analog
signal is below the level set with
signal to be broken and it will trip and display the error message "
disconnection detection function is disabled if
Title
6.15

Operation panel parameters

6
6.15.1

Prohibiting the change of parameter settings

• Function
This parameter specifies whether parameter setting is changeable or not.
■Setting methods
[Parameter setting]
Title
: Permitted _____
: Prohibited _____ All parameters are read/write-protected.
: Permitted _____
: Prohibited _____ Frequency can be changed from the operation panel but all other
: Permitted _____ The emergency stop function cannot be controlled from the operation panel
: Prohibited _____ The emergency stop function cannot be controlled from the operation panel
: Permitted _____ The emergency stop function cannot be controlled from the operation panel
: Prohibited _____ The emergency stop function cannot be controlled from the operation panel,
Note: Some parameters cannot be changed during operation, no matter how
4.1.4.)
■Canceling the setting
Only the setting of
: Analog input disconnection detection
Function
Analog input
disconnection detection
: Prohibition of change of parameter settings
Function
Prohibition of
change parameter 0~7 (See the explanation below.)
settings
and
and
parameters are read/write-protected.
and and
but all parameters are read/write-protected.
and and
frequency can be changed on the operation panel, but any other parameters
are write/read-protected.
can be changed anytime, no matter how it is set.
for 0.3 seconds (approx.), the inverter will assume the
is set to 0.0%.)
Adjustment range
0: Disabled
1~100%
Adjustment range
settings cannot be changed during operation. (Default)
settings also can be changed during operation.
settings cannot be changed during operation.
settings also can be changed during operation.
F-26
E6581090
." (The Analog input
Default setting
0
Default setting
is set. (See