Operation Frequency; Starting Frequency - Toshiba TOSVERT VF-nC1 Instruction Manual

6.5

Operation frequency

6.5.1

Starting frequency

• Function
The frequency set with the
frequency setting.
[Parameter setting]
Title
Output frequency [Hz]
6
Starting frequency setting
6.5.2 Start/stop control by means of frequency setting signals
• Function
The start/stop of operation can be controlled, by simply using frequency setting signals.
[Parameter setting]
Title
Output frequency [Hz]
: Starting frequency setting (Hz)
Function
Starting frequency setting (Hz) 0.5～10.0(Hz)
0
: Operation starting frequency (Hz)
: Operation starting frequency hysteresis (Hz)
Function
Operation starting frequency
(Hz)
Operation starting frequency
hysteresis (Hz)
＋
－
0 A
parameter is put out immediately after the completion of
Adjustment range
Adjustment range
0.0～ (Hz)
0.0～ (Hz)
The inverter starts to accelerate when the
frequency setting signal reaches point B.
Deceleration starts when the frequency
setting signal falls below point A.
B 100% Frequency command value
F-10
E6581090
Default setting
0.5
Time [sec]
Default setting
0.0
0.0