Slim Select Bay Module - Toshiba PORTEGE M400 Maintenance Manual

4.6 Slim select bay module

4.6

Slim select bay module

Removing the slim select bay module
The following describes the procedure for removing the slim select bay module. (See Figure
4-8 and 4-9.)
The explanation and figure shown below are the optical drive removing/installing.
CAUTION: Do not put fingers in the slim select bay module. It may cause injury.
1. Remove the following screw securing the latch and drive the removed screw into the
screw hole. (The slim select bay is unlocked.)
• M2.0×4.0B
2. While sliding the latch toward the arrow direction in the Figure 4-8, pull out the slim
select bay module to disconnect it from the system board.
Slim select bay module
PORTEGE M400 Maintenance Manual (960-541)
BIND screw
M2.0×4.0B BIND
Latch
Figure 4-8 Removing the slim select bay module
4 Replacement Procedures
×1
[CONFIDENTIAL] 4-17