4.16 Microphone/Front panel
4.16 Microphone/Front panel
Removing the Microphone/Front panel
The following describes the procedure for removing the microphone/front panel. (See Figure
4-30.)
1. Peel off the insulator and glass tape.
2. Disconnect two microphone cables (left and right) from the connector CN6060 and
CN6061 on the system board.
3. Remove the front panel from the base assembly.
4. Remove the microphone hold plates (left and right) and microphones (left and
right) from the front panel.
Front panel
Microphone
Microphone hold
plate
Microphone cable
(to CN6061)
Figure 4-30 Removing the microphone/front panel
PORTEGE M400 Maintenance Manual (960-541)
4 Replacement Procedures
Insulator
Glass tape
Microphone hold plate
Microphone cable
(to CN6060)
[CONFIDENTIAL]
Microphone
4-47