Slim Select Bay Module - Toshiba PORTEGE M780 Maintenance Manual

4 Replacement Procedures
4.7

Slim select bay module

Removing the slim select bay module
The following describes the procedure for removing the slim select bay module. (See Figure
4-9 and 4-10.)
The explanation and figure shown below indicate the optical drive removing/installing.
CAUTION: Do not put fingers in the slim select bay slot. It may cause injury.
1. Remove the following screw securing the latch.
 M2.54.0B
2. Set the removed screw into the screw hole. (The slim select bay is unlocked.)
3. While sliding the latch toward the arrow direction in the Figure 4-10, push the hook
of the slim select bay module and pull out the slim select bay module to disconnect it
from the system board.
Hook
4-20 [CONFIDENTIAL]
FLAT HEAD screw
Screw hole
Slim select bay module
Figure 4-9 Removing the slim select bay module
4.7 Slim select bay module
M2.54.0B FLAT HEAD
Latch
PORTÉGÉ M780 Maintenance Manual (960-809)
1