Toshiba PORTEGE M400 Maintenance Manual page 230

3 Tests and Diagnostics
15. PCI LAN
This option sets the Enable / Disable of the built-in LAN functions.
Enabled
Disabled
16. RAID ARRAY
Use this option to select the peripheral's mode.
This option sets the RAID configuration.
(a) Current State
This option indicates the current hard disk condition. Content set in "Create
State" is displayed, when booting BIOS setup next time.
Built in HDD1
Built in HDD2
(b) Create State
This option sets the RAID configuration level.
NOTE: All data of the hard disk is deleted when setting of the RAID configuration is
changed in the BIOS setup.
Therefore, it is recommended that the user password or the supervisor password
is registered to prevent changing of setting the RAID configuration by the third
party.
Moreover, registering the supervisor password can make add the restriction so
that a user without the management authority can not change the setting of the
BIOS setup.
Built in HDD1
Built in HDD2
(c) Execute Creation
This option is displayed, only when the setting is changed in the "Create
State".
Set the cursor bar to "Execute Creation" and press Space or Back Space.
The following message will appear:
Warning: If you change RAID array, you need to install OS
again. Are you sure? All data on the HDD(s) will be
3-112 [CONFIDENTIAL]
Enables built-in LAN functions. (Default)
Disables built-in LAN functions.
Displays RAID configuration level of the built-in HDD1.
Displays RAID configuration level of the built-in HDD2.
Sets RAID configuration level of the built-in HDD1.
Sets RAID configuration level of the built-in HDD2.
PORTEGE M400 Maintenance Manual (960-541)
3.31 SETUP