4 Replacement Procedures
4.19 MDC
Removing the MDC
The following describes the procedure for removing the MDC. (See Figure 4-35 and 4-36.)
1. Remove the following screws securing the MDC.
• M2.0×4.0B
2. Remove the MDC from the connector CN3010 on the system board.
3. Disconnect the MDC cable from the connector on the MDC.
MDC cable
4-54
[CONFIDENTIAL]
BIND screw
MDC
CN3010
Figure 4-35 Removing the MDC
×2
M2.0x4.0B BIND
M2.0x4.0B BIND
PORTEGE M400 Maintenance Manual (960-541)
4.19 MDC