Lcd Unit/Fl Inverter - Toshiba PORTEGE M400 Maintenance Manual

4.25 LCD unit/FL inverter

4.25 LCD unit/FL inverter

Removing the LCD unit/FL inverter
The following describes the procedure for removing the LCD unit/FL inverter. (See Figure 4-
43 to 4-46.)
NOTE: When replacing the LCD unit, do not give the hinge portion a strong press. It may
cause the breakage of the hinge assembly.
Also, Use a stand or something under the LCD part to keep the LCD part level
while replacing it.
1. Turn the display 180 degree and close the display. (LCD turns to the front.)
2. Peel off the mask seals (7 points) from the LCD mask and remove the following
screws securing the LCD mask.
• M2.5×6.0B
• M2.0×6.0S
3. Insert your fingers into the slot on both sides and remove the LCD mask while
releasing latches.
M2.0x6.0S BIND
(with mask seal)
M2.5x6.0B FLAT HEAD
(with mask seal)
PORTEGE M400 Maintenance Manual (960-541)
FLAT HEAD screw
BIND screw
M2.5x6.0B FLAT HEAD
(with mask seal)
Figure 4-43 Removing the LCD mask
4 Replacement Procedures
×6
×1
[CONFIDENTIAL]
LCD mask
Slot
4-63