Slim Select Bay Module - Toshiba PORTÉGÉ M700 Maintenance Manual

Fehler! Formatvorlage nicht definiert. Fehler! Formatvorlage nicht definiert.
Formatvorlage nicht definiert. Fehler! Formatvorlage nicht definiert.
4.7

Slim select bay module

Removing the slim select bay module
The following describes the procedure for removing the slim select bay module. (See Figure
4-10 and 4-11.)
The explanation and figure shown below indicate the optical drive removing/installing.
CAUTION: Do not put fingers in the slim select bay slot. It may cause injury.
1. Remove the following screw securing the latch.
• M2.5×4.0B
2. Set the removed screw into the screw hole. (The slim select bay is unlocked.)
3. While sliding the latch toward the arrow direction in the Figure 4-10, push the hook
of the slim select bay module and pull out the slim select bay module to disconnect it
from the system board.
Hook
PORTÉGÉ M700/M750 Maintenance Manual (960-661)
FLAT HEAD screw
Screw hole
Slim select bay module
Figure 4-10 Removing the slim select bay module
×1
M2.5×4.0B FLAT HEAD
Latch
[CONFIDENTIAL]
Fehler!
4-21