Gude Expert Power Control NET 24x Manual page 11

Configuration - HTTP
HTTP Port
Here you can enter hte HTTP port number, if necessary. Pos-
sible numbers are 1 ... 65534 (standard: 80). To get access to
EPC NET 24x, you have to enter the port number behind the IP
address of EPC NET 24x: http://192.168.0.2:1720
Require HTTP Password
Password protected access can be activated here. In this case,
a user and an admin password have to be defined. Passwords
have a maximum lengths of 15 characters.
Administrators are authorized to switch all ports and to modify
the settings of EPC NET 24x and of all ports. The username of
the admin is "admin".
Users are authorized to switch all ports but are not allowed to
modify the settings of neither
EPC NET 24x nor the ports.
The username of the user is
"user".
If you have forgotten your
password, activate the boot-
loader mode of EPC NET 24x,
start GBL_Conf.exe and deac-
tivate the password request.
All changes need a restart of
the firmware to get valid.
Figure 7 Config - HTTP
Expert Power Control NET 24x 9