Description expert net control 2i2o is a handy little device suitable for different kinds of telecontrolling. In- and output ports on the device allow to monitor and switch contacts through a TCP/IP network. expert net control 2i2o makes it possible to monitor and switch from any computer in the same LAN and from the Internet.
7) Connector for power supply unit Installation 1.) Connect the power supply cable to the of expert net control 2i2o and a socket. expert net control 2i2o now is booting and shortly after ready for usage. 2.) Plug the Ethernet cable into the ethernet connector (RJ45) of expert net control 2i2o and connect it to your Ethernet.
Configuration via webinterface Go to the website of expert net control 2i2o. Enter the IP address of expert net control 2i2o into the address line of your internet browser: http://”IP address of expert net control 2i2o”/ and press LOGIN.
Use DHCP Here you can set, if expert net control 2i2o shall get its TCP/IP settings directly from your DHCP server. If DHCP is activated, expert net control 2i2o proves if a DHCP server is active inside of your LAN. Then expert net control 2i2o requests TCP/IP settings from this server.
Configuration - IP ACL IP Access Control List (IP ACL) acts as an IP filter for your expert net control 2i2o. Wether it is active hosts and subnets only can contact expert net control 2i2o, if their IP adresses are stated in this IP ACL.
Bootloader mode To activate the bootloader mode of expert net control 2i2o the select button must be pushed while restarting the device. In bootloader mode it is possible to disable the password protection, to update the firmware and to restore the default settings by running the program GBL_Conf.exe.
More information, current drivers and software can be found on http://www.gude.info. In case of further questions, about installation or operation of expert net control 2i2o, please have look at www.gude.info/ wiki or do not hesitate to contact our support (mail@gude.info).
Need help?
Do you have a question about the Expert net control 2i2o and is the answer not in the manual?
Questions and answers