Cleaning The Mask In The Home - ResMed Mirage Kidsta User Manual

61801r1.book Page 4 Friday, September 10, 2004 10:02 AM
C M
LEANING THE ASK IN THE
H
OME
Notes:
Wash the headgear before first time use,
•
as the dye may run. It is important to
always handwash the headgear.
The headgear may be washed without
•
being disassembled.
D /A
AILY FTER EACH USE
Handwash the mask components in
lukewarm, soapy water. Use pure soap
(an example of pure soap is Dove
unscented; made by Unilever). Rinse the
components well and allow them to air dry
out of direct sunlight.
W
EEKLY
Handwash the headgear in warm, soapy
water. Use pure soap. Rinse well and allow
it to air dry out of direct sunlight.
CAUTIONS
.
Do not use solutions containing
•
bleach, chlorine, alcohol, aromatics,
moisturisers, antibacterial agents, or
scented oils to clean any part of the
mask system or air tubing. These
solutions may cause damage and
reduce the life of the product.
Do not expose any part of the mask
•
system or tubing to direct sunlight as
it may deteriorate.
If any visible deterioration of a mask
•
component is apparent (cracking,
crazing, tears etc), the mask
component should be discarded and
replaced.
C
LEANING THE
P
ATIENTS
The mask system (excluding the swivel and
short tube) is validated for multipatient use.
Clinicians should refer to the Masks
Disinfection/Sterilisation Guide for details.
To clean the headgear between patients,
use the method described in the previous
section "Cleaning the Mask in the Home".
R
EASSEMBLING THE
See Figure E.
1 Insert the mask cushion into the groove
soap,
®
of the mask frame (Fig. E-1). Fit the top
section first and then work your way
around, pushing the mask cushion into
the mask frame.
Note:
The diamond markers on the mask
frame and on the mask cushion (one on
top, two at the bottom) must line up.
2 Push the ports cap onto the mask ports
(Fig. E-2).
3 Attach the vent cover to the mask
elbow. To do this, insert the elbow into
the ring of the vent cover (Fig. E-3).
Push the ring to the top so that the vent
cover is over the back of the elbow.
Then, press the lip of the vent cover to
ensure that it is securely seated in the
groove of the elbow.
4 Connect the short air tubing to the mask
elbow.
5 Connect the swivel to the main air
tubing, ready for next use (Fig. E-4).
M
ASK BETWEEN
M
ASK