Page 2
Forehead pads Forehead support Tampons frontaux Support frontal Almohadillas para la frente Apoyo para la frente Almofadas da testa Suporte da testa Mask Frame Entourage rigide Mask Cushion Armazón de la mascarilla Bulle du masque Armação da máscara Almohadilla de la mascarilla Almofada da máscara Mask elbow Cushion clip...
Mirage Activa Nasal Mask ™ The M ™ nasal mask is an accessory to a non- IRAGE CTIVA continuous ventilator (respirator), intended for multi-patient use for adult patients prescribed continuous positive airway pressure (CPAP) or bilevel therapy in hospital, clinic, and/or home environments.
Page 5
bilevel device is turned on and functioning properly, new air from the flow generator flushes the exhaled air out through the attached mask exhalation port. However, when the CPAP or bilevel device is not operating, enough fresh air will not be provided through the mask, and exhaled air may be rebreathed.
ARTS OF THE See Figure A for a list of all parts. The M mask cushion uses ResMed's innovative IRAGE CTIVA ™ technology. The A is an expandable...
Page 7
6 The pads of the forehead support should lightly touch your forehead when the mask is in place. Adjust the forehead support by depressing its tab and moving it to one of the other slot positions (Fig. C-7). 7 Connect one end of the main air tubing to your CPAP or bilevel device and the other end to the swivel.
Note: Select "Standard" as the mask option, when using ResMed AutoSet™ devices. EMOVING THE To remove the M mask, squeeze the headgear clips IRAGE CTIVA (Fig. C-a). This releases the headgear clips from the mask frame. Pull the mask and headgear away from your head.
5 Detach the cushion assembly from the mask frame. To do this, squeeze the two side latches on the cushion clip until they disengage from the mask frame (Fig. C-4). Then pull the mask cushion assembly out and away from the mask frame (Fig.
Page 10
Cleaning, disinfection and sterilization instructions are available from the ResMed website, www.resmed.com/masks/sterilization/americas. If you do not have Internet access, please contact your ResMed representative. EASSEMBLING THE 1 Attach the forehead pads to the forehead support. To do this, place the forehead pad plugs into the two round holes of the forehead support.
Page 11
Fit the top section first (Fig. D-3), then work your way around, inserting the cushion clip into the mask cushion. Ensure that the cushion clip does not pinch any part of the mask cushion (Fig. D-4). The cushion clip should fit snugly inside the groove of the mask cushion.
IMITED ARRANTY ResMed warrants that your ResMed mask system, including its components: mask frame, cushion, headgear, tubing and other accessories (“Product”) shall be free from defects in material and workmanship for a period of ninety (90) days from the date of purchase by the initial consumer.
Page 13
Manufacturer: ResMed Ltd 1 Elizabeth Macarthur Drive Bella Vista NSW 2153 Australia Distributed by: ResMed Corp 9001 Spectrum Center Boulevard San Diego CA 92123 USA ResMed (UK) Ltd 96 Milton Park Abingdon Oxfordshire OX14 4RY UK See www.resmed.com for other ResMed locations worldwide.
Need help?
Do you have a question about the Mirage Activa and is the answer not in the manual?
Questions and answers