Switch Board Cable - HP ENVY x360 Series Maintenance And Service Manual

Switch board cable

NOTE: The switch board cable is available using spare part number L53537-001.
Before removing the switch board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the switch board cable:
1. Release the ZIF connector (1) to which switch board cable is connected, and then disconnect the switch
board cable from the system board.
2. Release the ZIF connector (2) to which switch board cable is connected, and then disconnect the switch
board cable from the switch board.
3. Remove the switch board cable (3).
Reverse this procedure to install the switch board cable.
38 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 30).
28).